Updated 1-11-23
Phil walks you through how to seal penetrations and look super pro doing it.
⏱️⏱️Chapters⏱️⏱️
00:00 Put tape around the flange
00:25 When you pull tape off magically square
00:52 Any kind of caulking will shrink
01:36 How to get tar off you
01:55 And you look like a pro
➤➤Shop Amazon https://amzn.to/3CxD1T4
➤➤Tool lists & recommended products🧰 https://straightarrowrepair.com/0lvf
Transcript:
What we’ve done now is put tape around the flange about an inch and half to two inches away where you can get the elasticool or tar to bind to the metal. And then I make sure that I cover up any nail holes that might have been there. And spread it out, try to feather it out near the tape. And that way.
When we pull the tape off, it looks like you did a perfectly good square. Even though you might have gotten over into the tape quite a bit. It’s what I’ve been doing for years and years. And I know there’s people that say you should use this, but I’m telling you this works and works good, easy to maintain, inexpensive and any kind of caulking shrinks. It really shrinks. When we pull this tape off it will have square edges. We’ll show you tearing the tape off later.
I’m cleaning this and I’m going to try not to get the poo on me.
“And how can you get tar off if you get in a place that.”
Any kind of oil-based product oil, wd40, gasoline is kind of hard on your skin, but any kind of oil will get it off. After that it’s a hot bath. There you go.
“That does look really cool.”
It’s looks from the ground like you know what you’re doing.
“You planned it all. All right.”
